Pipe Burst? Do These 5 Things Before the Plumber Arrives
A burst pipe can pour hundreds of gallons into your home in an hour. The repair is the plumber's job — but the damage is decided by what you do in the first five minutes. Here is the order that matters.
What are the 5 things to do when a pipe bursts?
- Turn off the main water supply. This is the single most important step. Your main shut-off is usually where the water line enters the house — near the street-side wall, in the basement, garage or utility room, or by the meter. Turn it clockwise until the water stops. (Not sure where yours is? Read our shut-off valve guide now, before you ever need it.)
- Switch off electricity in the affected area. If water is near outlets, appliances or your breaker panel, turn off power to that part of the house at the breaker box — from a dry spot, with dry hands. Water and electricity do not mix; if you cannot reach the breakers safely, skip this and keep people out of the room.
- Drain what is left in the pipes. Open the cold taps, starting with the lowest one in the house, and flush toilets once. This empties the lines so the burst point stops dripping and you can see the true extent of the leak.
- Protect the room, then find the break. Move furniture, electronics and anything stored on the floor. Put a bucket under the leak and towels around it. If you can see the burst section, note where it is — the plumber will ask.
- Call a plumber, and take photos while you wait. Call +1 952-248-8107 and describe where the break is and whether the water is off. Then photograph the damage for your insurer before you clean up — insurers want the "before" pictures, not the tidy ones.
What should you never do with a burst pipe?
Do not ignore a slow drip and hope — a pipe that has burst once is telling you about pressure or corrosion, and the next failure is usually bigger. Do not seal a burst with tape as a "repair": tape and clamps are a same-day holding measure only. And do not turn the water back on to "test" it before the repair is done.
Why do pipes burst?
The usual causes are freezing (water expands as it turns to ice), corrosion in older metal pipes, and water pressure that runs too high for too long. If your pipes froze, tell the plumber — neighbouring sections may be split too, and checking them in the same visit is far cheaper than a second emergency call.
Water flowing right now? Skip the reading: shut the main valve, then call +1 952-248-8107.